Edelbrock 2010 Manual de instalación descargar pdf (Pagina 20)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 12

25. Remove four body pins (two on each side) by reaching

up through the bottom of the fascia.

26. Place multiple layers of masking tape on the nose of

the hood as well as the portion of the front fascia directly

below the hood to protect from damage during removal.

27. The sides of the fascia can be pulled away from the

clips holding it in place, then down off the studs. The

center section must be pulled up and over the nose section,

and the whole assembly pulled straight off and set aside.

28. Disconnect the Mass Airflow Sensor connector.

29. Use a flat head screwdriver to loosen the Throttle Body

to inlet tube worm clamp.

30. Disconnect the PCV tube from the air inlet tube.

31. Lift the airbox and resonator tube off the locator pins

and remove it and the air inlet tube as an assembly.

32. Use a 16mm socket and a breaker bar to turn the

tensioner until the serpentine belt has enough slack to

remove it.

33. Remove coil covers from valve covers by lifting up and

working fuel line through slot on driver side.

34. Disconnect the Electronic Throttle Control connector

on the passenger side of the throttle body.

35. Use a 10mm socket to remove the four bolts holding

in the throttle body and set it aside.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 40 41

Sin comentarios

Edelbrock 2010 Manual de instalación Pagina 20