Edelbrock 2010 Manual de instalación descargar pdf (Pagina 25)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 17

77. Use a 6mm Allen tool to hold the tie rod ball stud

stationary while using an 18mm wrench to loosen the nut.

78. Use GM Ball Joint Separator #J 42188 to separate the

steering knuckle from the tie rod ball stud then remove the

tool and the nut. Use this procedure for both sides.

79. Remove the lower nut from the endlink by placing an

8mm wrench on the end of the stud while using an 18mm

wrench on the nut. Repeat this procedure on both sides.

80. Use a 13mm socket to remove the four bolts retaining

the stabilizer brackets.

81. Use a 10mm socket to remove the two nuts retaining

the brake pressure modulator valve.

‘09 and Later

2008 Only

82. Place a catch pan below the steering gear then use an

18mm line wrench to disconnect the two power steering

lines from the steering gear.

83. Use a 10mm socket to remove the bolts retaining the

power steering line brackets or fluid cooler, if equipped.

84. Use a floor jack to support the oil pan.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 40 41

Sin comentarios

Edelbrock 2010 Manual de instalación Pagina 25