Edelbrock 2010 Manual de instalación descargar pdf (Pagina 35)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 27

181. Use a 13mm socket to attach the harness power wire

to the main positive terminal.

182. Use a 10mm socket to attach the ground wire to the

ground stud near the relay.

183. Reinstall the fender well fuse box bolt.

184. Install supplied 15/32” hose on brake booster and

secure fitting with a hose clamp supplied in Bag #2.

185. Install the stock O-ring port gaskets in the supercharger

manifold.

186. Install the supplied Manifold to EVAP Solenoid Hose on

the manifold fitting below the hub snout.

187. Clear engine valley of any hoses, wires, tools, etc.

Lay the intercooler-to-reservoir tank hose in the engine

bay, routed along the firewall behind the oil pressure

sensor, and connect it to the intercooler reservoir inlet,

securing the fitting with a hose clamp supplied in Bag #2.

188. (Refer to the Dry Sump Routing Guide on page 7 for

a clear depiction of the hose routing procedure described

below.) Attach the dry sump breather hose assembly to the

driver side valve cover fitting, then route the rest of the hose

along the firewall and over to the passenger side. Connect

the middle hose section to the passenger side valve cover

provision and the straight fitting to the rear dry sump tank

fitting. Cut the supplied dry sump hose near the rear dry

sump fitting and install the supplied tee adapter in line with

that hose. Route the short section of hose extending from

the tee adapter to the auxiliary tank fitting and attach it.

189. Remove the tape covering the intake ports. Since two

of the stock manifold bolt hole provisions in the cylinder

heads break into the crankcase and are not used with this

supercharger, install the two button head bolts supplied in

Bag #3 in the front passenger side and rear driver side bolt

holes to ensure a good seal. With the assistance of one

or more people, lift the supercharger assembly onto the

engine.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Sin comentarios

Edelbrock 2010 Manual de instalación Pagina 35