Edelbrock 2010 Manual de instalación descargar pdf (Pagina 21)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 13

36. Disconnect the ignition coil harness and O2 sensor

connectors then disconnect the spark plug wires from the

ignition coils.

37. Use a 10mm socket to remove the five bolts retaining

the coil bracket on each valve cover then remove both coil

bracket assemblies.

38. Use a fuel line removal tool to disconnect the fuel line

from the rails using a shop rag to absorb excess fuel.

39. Disconnect and remove the hose connecting the

passenger and driver side valve covers to the rear dry sump

tank fitting.

40. Disconnect all eight fuel injector connectors.

41. Use a 10mm socket to remove the four fuel rail bolts.

NOTE: You will also need to remove one 8mm manifold bolt

and bracket before removing the fuel rails.

42. Lift the injectors out of the manifold and work the rails

forward until they can be set aside.

43. Use an 8mm socket to loosen the two rear passenger

side manifold bolts. Slide the manifold cover out from under

the bracket that those bolts retain, and remove it.

44. Use a 10mm socket to remove the seven remaining

manifold bolts (out of ten).

45. Disconnect the EVAP solenoid electrical connector.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 40 41

Sin comentarios

Edelbrock 2010 Manual de instalación Pagina 21