Edelbrock 2010 Manual de instalación descargar pdf (Pagina 38)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 30

216. Route the serpentine belt according to the diagram.

Note that you must slide the belt around the bottom of the

bracket to get the belt on the lower passenger side idler

pulley.

217. Use a breaker bar and a 16mm socket to push the

tensioner enough to get the belt on, then double check the

routing.

218. Use a 10mm socket, an extension bar, the four stock

bolts and OEM seal to install the throttle body. Torque the

bolts to 91 in-lbs.

219. Connect ETC harness to the throttle body motor.

220. Connect the intercooler hose assembly to the two

upper hose fittings at the front of the manifold.

210. Install the stock grommets into the coil cover brackets

supplied in Bag #6.

211. Use a 10mm socket to remove the bolts securing the

#2, #3, #6 and #7 ignition coils.

212. Install the coil cover brackets on top of the ignition

coils, then use a 10mm socket to secure them with the

stock bolts.

213. Tuck the wire harness tight against the fuel rails.

Verify that nothing will be pinched or damaged when the

coil covers are installed.

214. Use a 7/16” deep socket to install the four ball studs

supplied in Bag #6 onto the supplied coil covers.

215. Plug the OEM engine harness MAP sensor connector

into the supplied MAP harness then route the harness to the

vicinity of the air intake.

1 2 ... 33 34 35 36 37 38 39 40 41

Sin comentarios

Edelbrock 2010 Manual de instalación Pagina 38